Articles

bl-bdd-kb mini

Article Index: 034

BDD-KB

  • Raising capability on two sides
  • Folding capability

Dimensions

Standard height:

100–500 mm

Standard length:

up to 15000 mm

Special dimensions:

upon request

Width:

50 mm


 

Suitable for crack-free surfaces with up to 20 mm (± 10 mm) of floor/ground unevenness, e.g. concrete, corrugated sheet metal, tiles, stones, etc.

A special barrier for large distances.

The Retention Barrier is comprised of four trapezoidal, integral hollow aluminium profiled sections. A compressible, highly adaptable special seal is affixed on their lower side and end faces.

Both swivelling devices are securely mounted and sealed to the floor/ground and wall next to the opening to be secured. The barrier bodies are securely bolted into the hinges. These sections stand vertically in the resting position and are secured in this position in conformity with accident prevention measures to avoid unintentional release. When being deployed, the barrier section without the tensioning device is first unlocked and lowered into the closing position and the “rider” section folded out into the locking position. The opposing barrier section with the attached tensioning devices is then employed in the same manner and all elements tensioned against each other and against the floor/ground surface.

With certain lengths and heights, both closure barriers are counterbalanced with weights in the factory. Gas-charged springs are standard. Operation by means of a manual winch is recommended for very large barriers.

Barrier bodies and mounting fixtures are furnished with a red paint finish, preferably “traffic red” RAL 3020. The remaining metal components are galvanized or made of aluminium.

Download Brochure